Road Spike Barrier

LZD-6G portable remote control roadblock is composed of high-performance reinforced plastic blocks and stainless steel deflated hollow needles. It adopts an electromechanical integrated remote control device, which is easy to operate, safe and reliable. It can be set up at any time and deployed on the move without affecting the normal smooth flow of roads. It is an indispensable advanced equipment for law enforcement departments when they need to set up checkpoints to intercept suspected vehicles.

1. Before use, ensure that the lithium battery in the power box is charged for a sufficient time to keep the power supply voltage between 11V-12.6V.

2. On the road section where the interception task is required, open the right box cover of the roadblock packaging box, roll out the roadblock roll, remove the elastic hook used to fix the roadblock, lean against the side of the roadside, and roll towards the road surface where the vehicle is to be intercepted.

3. Connect the wiring between the remote control box and the roadblock head, insert one end of the three-core connecting cable into the roadblock head connection jack, and the other end into the remote control box three-core connection jack.

4. Open the upper cover of the power box, pull the power switch to the built-in power supply, the voltmeter displays the voltage value, the device enters the working state, and pull out the remote control antenna to increase the receiving distance.

5. When it is necessary to perform the task of intercepting the suspect's vehicle, press the "A" button of the remote control, the power box will emit a "beep" sound, the red indicator light in the upper left corner of the power box will light up, and the stainless steel hollow needle in the roadblock will automatically stand up. At this time, if you force your way through the roadblock, the wheel will be pierced by several stainless steel tire-breaking hollow needles, and the tire will be deflated immediately within two seconds. You can't continue to drive and can only stop.

6. After the interception mission is completed, press the "B" button of the remote control again, and the erected stainless steel hollow needle will rotate back to its original position and enter the standby state.

7. To recover the remote control blocking roadblock, roll the roadblock block into a circle, fix the roadblock block with an elastic hook belt, turn off the power switch of the remote control box, and put the remote control box into the empty space in the middle of the roadblock block. Hold the roadblock box with your left hand, roll the roadblock block into the box with your right hand, put in the connecting cable, and buckle the box cover.

8. This remote control roadblock is also equipped with an external power connection cable. When the power supply voltage in the remote control box is insufficient and cannot work normally, one end of the car connection cable can be plugged into the external power connection jack of the remote control box, and the other end can be plugged into the 12V car cigarette lighter jack. Pull the power switch of the remote control box to the external power position. The operation is the same as the above method.

No. Accessory Name Remarks

1 Remote Control Box 1 set

2 Control Cable 1 piece

3 Car Cable 1 piece

4 Deflation Hollow Needle 10 pieces (with rubber sleeve)

5 Charger 1 piece

6 Needle Installation Tool 1 piece

7 Instruction Manual 1 piece

Hot Tags: road spike barrier, China road spike barrier manufacturers, suppliers, factory, portable road safety barricade system